Facultative Ponds

In facultative ponds, waste conversion is performed by a combination of aerobic, anaerobic, and facultative bacteria. As shown in Figures 7.27.1 and 7.27.2, the facultative pond is comprised of three zones: (1) a surface zone where algae and bacteria thrive symbiotically, (2) an anaerobic zone at the bottom sludge layer where accumulated or-ganics are decomposed by anaerobic bacteria, and (3) an aerobic-anaerobic zone in the middle where facultative bacteria are responsible for waste conversion. Using the oxygen produced by algae growing near the surface, aerobic and facultative bacteria oxidize soluble and colloidal organics, producing carbon dioxide. This carbon dioxide is used by the algae as a carbon source. Anaerobic waste conversion in the bottom zone produces dissolved organ-ics and gases such as CH4, CO2, and H2S that are either oxidized by aerobic bacteria or released to the atmosphere.

Facultative stabilization pond designs (see Figure 7.21.9) are similar to those of aerobic ponds; i.e., they are usually based on loading factors developed from field experience. Unlike aerobic ponds, facultative ponds promote settling of organics to the anaerobic zone. Therefore, quiescent conditions are required, and dispersion factors in facultative ponds vary from 0.3 to 1.0 (Metcalf and Eddy, Inc. 1991).

The sludge accumulation in facultative ponds calls for another deviation from aerobic pond design. In cold climates, a portion of BOD5 is stored in the accumulated sludge during the winter months. In the spring and summer as the temperature rises, accumulated BOD5 is anaer-obically converted. The end products of conversion—gases and acids—exert an oxygen demand on the wastewater. This demand can exceed the oxygen supply provided by algae and surface reaeration in the upper layer of the pond. In this case, wastewater treatment facilities should use surface aerators capable of satisfying 175 to 225% of the incoming BOD5. The accumulation of sludge in the facultative pond can also lead to a higher SS concentration in the effluent, reducing overall pond performance.

0 0

Post a comment