References

Assies, J.A. 1991. Introduction paper. SETAC-Europe Workshop on

Environmental Life Cycle Analysis of Products, Leiden, Netherlands:

Center for Environmental Science (CML), 2 December 1991.

Battelle and Franklin Associates. 1992. Life cycle assessment: Inventory guidelines and principles. EPA/600/R-92/086. Cincinnati, Ohio: U.S. EPA, Risk Reduction Engineering Laboratory, Office of Research and Development.

Consoil, F.J. 1993. Life-cycle assessments—current perspectives. 4th Pollution Prevention Topical Conference, AIChE 1993 Summer National Meeting, Seattle, Washington, August, 1993.

Doerr, W.W. 1991. WHAT-IF analysis. In Risk assessment and risk management for the chemical process industry. Edited by H.R. Greenberg and J.J. Cramer. New York: Van Nostrand Reinhold.

Greenberg, H.R. and J.J. Cramer. 1991. Risk assessment and risk management for the chemical process industry. New York: Van Nostrand Reinhold.

Harwell, M.A. and J.R. Kelly. 1986. Workshop on ecological effects from environmental stresses. Ithaca, N.Y.: Ecosystems Research Center, Cornell University.

O'Mara, R.L. 1991. Failure modes and effects analysis. In Risk assessment and risk management for the chemical process industry. Edited by H.R. Greenberg and J.J. Cramer. New York: Van Nostrand Reinhold.

Science Advisory Board. 1990. The report of Ecology and Welfare Subcommittee, Relative Risk Reduction Project. SAB-EC-90-021A. Washington, D.C.: U.S. EPA.

Stoop, J. 1990. Scenarios in the design process. Applied Ergonomics 21, no. 4.

Suter, Glenn W.I. 1990. Endpoints for regional ecological risk assessment. Environmental Management 14, no. 1.

0 0

Post a comment