Sludge Removal

As solids settle to the bottom of a basin, a sludge layer develops. This layer must be removed because the solids can become resuspended or tastes or odors can develop. Wastewater treatment plants can manually remove the sludge by periodically draining basins and flushing the sludge to a hopper and drawoff pipe. This practice is recommended only for small installations or installations where not much sludge is formed. Mechanical removal is usually warranted.

For rectangular basins, sludge removal equipment is usually one of the following mechanisms (AWWA 1990):

A chain and flight collector (see Figure 7.17.1) consisting of a steel or plastic chain and redwood- or fiberglass-reinforced plastic flights (scrapers). A traveling-bridge collector (see Figure 7.17.10) consisting of a moving bridge, which spans one or more basins. The mechanism has wheels that travel along rails mounted on the basin's edge. In one direction, the scraper blade moves the sludge to a hopper. In the other direction, the scraper retracts, and the mechanism skims any scum from the water's surface. A floating-bridge siphon collector (see Figure 7.17.11) using suction pipes to withdraw the sludge from the basin. The pipes are supported by foam plastic floats, and the entire unit is drawn up and down the basin by a motor-driven cable system. For suction sludge removal, the velocity can be 1 m/min (3 fpm) because the main concern is not the resuspension of settled sludge but the disruption of the settling process.

To keep solids from returning to the cleaned liquid, scrapers should operate at velocities below 1 fpm. The power requirements are about 1 hp per 10,000 sq ft of tank area, but straight-line collectors must have motors about ten times that strong to master the starting load (Fair, Geyer, and Okun 1968).

Circular basins are usually equipped with scrapers or plows, as shown in Figure 7.17.3. These slant toward the center of the basin and sweep sludge toward the center of the basin, then to the effluent hopper or pipe. The bridge can be fixed as illustrated, or it can move with the truss.

Regardless of the collection method, the sludge is washed or scraped into a hopper. It is then pumped to sludge discharge treatment facilities.

Was this article helpful?

0 0

Post a comment