Stabilization Ponds

A stabilization pond is a low-cost treatment process widely used in small communities and industrial facilities. It is a shallow body of wastewater contained in an earthen basin, using a completely mixed biological process without solids return. Mixing is usually provided by natural processes such as wind, heat, or fermentation; however, mixing can be induced by mechanical or diffused aeration.

One of three types of environmental conditions—fostering three corresponding types of biological activity—

FIG. 7.27.1 Elevation diagram of facultative lagoon strata and operation.

can prevail in a stabilization pond process: aerobic, aerobic-anaerobic, and anaerobic. Aerobic ponds are used primarily for treating soluble organic wastes and effluents from wastewater treatment plants. Facultative ponds (see Figure 7.27.1), in which aerobic-anaerobic conditions exist, are the most common type and are used to treat domestic waste and a variety of industrial waste. Anaerobic ponds are applied where rapid stabilization of strong organic waste is required (see Figure 7.22.4). Wastewater treatment facilities commonly use anaerobic ponds in series with facultative ponds to provide complete treatment.

Aerobic and facultative ponds are biologically complex. Figure 7.27.2 shows the general reactions that occur. Part of the organic matter in the influent is oxidized by bacteria, producing ammonia, carbon dioxide, sulfate, water, and other end products of aerobic metabolism. These products are subsequently used by algae during daylight to produce oxygen. Bacteria use this supplemental oxygen and the oxygen provided by wind action to decompose the other part of the organic matter.

In states where stabilization-pond-treatment processes are commonly used, regulations govern pond design, installation, and operation. A minimum retention time of 60 days is often required for flow-through facultative ponds receiving untreated wastewater (Metcalf and Eddy, Inc. 1991). Frequently, retention times as high as 120 days are specified. However, even with a low retention time of 30 days, a high degree of coliform removal is ensured (Metcalf and Eddy, Inc. 1991). Other typical standards (see Figure 7.27.3) include embankment slopes (1:3 to 1:4), organic loading rate (2.2 to 5.5 g BOD/m2-day, depending on climate), and permissible seepage through the bottom (0 to 6 mm/day). In some climates, treatment facilities can operate ponds without discharge to surface waters (McGhee 1991).

Bacteria CH4 + CO2 + NH3

FIG. 7.27.1 Elevation diagram of facultative lagoon strata and operation.

FIG. 7.27.2 Schematic of a stabilization pond.

0 0

Post a comment